diff --git a/README.i2c-intf b/README.i2c-intf index ec6c02d..930b6e1 100644 --- a/README.i2c-intf +++ b/README.i2c-intf @@ -42,21 +42,37 @@ Registers 0x70: Flashing mode unlock key (writing 0x46 to this register unlocks the flashing mode.) + 0x71: Flashing control Writing various commands to this register makes the MCU execute them, if the MCU is not executing the previous command. Available commands: + 0x52 - read a block of data from code ROM 0x57 - write a block of data to code ROM 0x45 - erase the code rom memory block (128B) 0x43 - confirm the validity of the firmware and enable redirection to it from the main app (this redirection is automatically disabled before executing the 0x57 command) + + This register will ignore further commands as long as the last operation + is still in progress. This register will contain the code of the + currently executed operation, and will be cleared after the operation + finishes. Completion is also signalled by pulsing the INT pin shortly. + + If the operation fails, this register will contain value 0xff. If it + succeeds it will contain value 0x00. + 0x7d: target address low byte 0x7e: target address high byte + 0x7f: CRC8 calculated for the 128B block of data from 0x80-0xff - this must be written by the user when preparing data for write - operation - - this is update by the MCU after reading the data from flash memory + operation, MCU checks the CRC8 of the data and compares it against + the value in this register before starting the execution of + 0x57 command + + - this is updated by the MCU after reading the data from flash memory + 0x80: 128B block of EEPROM data (either read from code memory or to be ... written) 0xff