case when 401 or 407 are returned, *IF* no auth credentials have been given.
The CURLOPT_FAILONERROR option is not possible to make fool-proof for 401
and 407 cases when auth credentials is given, but we've now covered this
somewhat more.
You might get some amounts of headers transferred before this situation is
detected, like for when a "100-continue" is received as a response to a
POST/PUT and a 401 or 407 is received immediately afterwards.
Added test 281 to verify this change.
and while doing so it became apparent that the current timeout system for
the socket API really was a bit awkward since it become quite some work to
be sure we have the correct timeout set.
Jeff then provided the new CURLMOPT_TIMERFUNCTION that is yet another
callback the app can set to get to know when the general timeout time
changes and thus for an application like hiperfifo.c it makes everything a
lot easier and nicer. There's a CURLMOPT_TIMERDATA option too of course in
good old libcurl tradition.
handle that is part of a multi handle first removes the handle from the
stack.
- Added CURLOPT_SSL_SESSIONID_CACHE and --no-sessionid to disable SSL
session-ID re-use on demand since there obviously are broken servers out
there that misbehave with session-IDs used.
CURLOPT_NOBODY is set true. PREQUOTE is then run roughly at the same place
in the command sequence as it would have run if there would've been a
transfer.
CURLOPT_MAX_RECV_SPEED_LARGE that limit tha maximum rate libcurl is allowed
to send or receive data. This kind of adds the the command line tool's
option --limit-rate to the library.
The rate limiting logic in the curl app is now removed and is instead
provided by libcurl itself. Transfer rate limiting will now also work for -d
and -F, which it didn't before.
autotools project, which optionally (default=yes) uses libcurl on a system
without a (usable) libcurl installation, but not specifying
`--without-libcurl', configure determines correctly that no libcurl is
available, however, the LIBCURL variable gets expanded to `LIBCURL = -lcurl'
in the resulting Makefiles.
David Shaw fixed the flaw.
type to the already provided type CURLPROXY_SOCKS4.
I added a --socks4 option that works like the current --socks5 option but
instead use the socks4 protocol.
an app can use to let libcurl only connect to a remote host and then extract
the socket from libcurl. libcurl will then not attempt to do any transfer at
all after the connect is done.
