Prior to this change if there was a 303 reply to a PUT request then
the subsequent request to respond to that redirect would also be a PUT.
It was determined that was most likely incorrect based on the language
of the RFCs. Basically 303 means "see other" resource, which implies it
is most likely not the same resource, therefore we should not try to PUT
to that different resource.
Refer to the discussions in #5237 and #5248 for more information.
Fixes https://github.com/curl/curl/issues/5237
Closes https://github.com/curl/curl/pull/5248
The purpose with this variable is to provide a port number that is
reasonably likely to not have a listener on the local host so that tests
can try connect failures against it. It uses port 47 - "reserved"
according to IANA.
Updated six tests to use it instead of the previous different ports.
Assisted-by: Emil Engler
Closes#5270
This fixes the error: 'for' loop initial declaration used outside C99
mode by declaring the loop increment variable in the beginning of the
block instead of inside the for loop.
Fixes#5254
Reviewed-by: Daniel Gustafsson <daniel@yesql.se>
FTP, IMAP, POP3, SMTP and their IPv6 versions are now all on dynamic
ports
Test 842-845 are unfortunately a bit hard to move over to this concept
right now and require "default port" still...
The runtests script now always performs variable replacement on the
entire test source file before the test gets executed, and saves the
updated version in a temporary file (log/test[num]) so that all test
case readers/servers can use that version (if present) and thus enjoy
the powers of test case variable substitution.
This is necessary to allow complete port number freedom.
Test 309 is updated to work with a non-fixed port number thanks to this.
Since the Windows versions of both programs would write Windows
PIDs to their pidfiles which we cannot handle, we need to use
our known perl.exe Cygwin/msys PID together with exec() in order
to tie the spawned processes to the existance of our perl.exe
The perl.exe that is executing secureserver.pl and sshserver.pl
has a Cygwin/msys PID, because it is started inside Cygwin/msys.
Related to #5188
- Ignore intermediate progress updates.
- Support locales that use a character other than period as decimal
separator (eg 100,0%).
test1148 checks that the progress finishes at 100% and has the right
bar width. Prior to this change the test assumed that the only progress
reported for such a quick transfer was 100%, however in rare instances
(like in the CI where transfer time can slow considerably) there may be
intermediate updates. For example, below is stderrlog1148 from a failed
CI run with explicit \r and \n added (it is one line; broken up so that
it's easier to understand).
\r
\r################################## 48.3%
\r######################################################################## 100.0%
\n
Closes https://github.com/curl/curl/pull/5194
With this bit set, my mac successfully resolves "ip6-localhost" when in
fact there is no such host known to my machine! That in turn made test
241 wrongly execute and fail.
Closes#5202
test1294: "split request" being when the entire request isn't sent in
the first go, and the remainder is sent in the PERFORM state. A GET
request is otherwise not sending anything during PERFORM.
test1295: same kind of split but with POST
Closes#5197
