mirror of
https://github.com/mcgurk/Arduino-USB-HID-RetroJoystickAdapter
synced 2024-12-22 07:28:53 -05:00
| .. | ||
| README.md | ||
| Sony_Playstation_Multitap.jpg | ||
Sony Playstation
What do I need?
- You will need one Atmega32u4 (e.g. Arduino Leonardo).
Wiring the Controller
As the following picture from the amazing CuriousInventor PS2 Interface Guide shows, PlayStation controllers use 9 pins:
| Pin # | Signal | Direction | Notes |
|---|---|---|---|
| 1 | Data | Controller -> PlayStation | Open Collector |
| 2 | Command | PlayStation -> Controller | |
| 3 | Motor Power | 7.5V | |
| 4 | Ground | ||
| 5 | Power | 3.6V | |
| 6 | Attention | PlayStation -> Controller | |
| 7 | Clock | PlayStation -> Controller | |
| 8 | (Unknown) | ||
| 9 | Acknowledge | Controller -> PlayStation | Open Collector |
You are advised not to rely on wire colors, but rather on pin positions. The wires in the image come from an official Sony controller, I expect their colors to be fairly consistent among all Sony controllers, but you shouldn't really trust them.
-- documentation taken from https://github.com/SukkoPera/PsxNewLib